5/7/2023 0 Comments Magnet tape↳ Is this connected to that? Use a homemade electronic tester to find out if electricity can flow between two objects.↳ Investigating the 'Mpemba Effect': Can Hot Water Freeze Faster than Cold Water?.↳ From Dull to Dazzling: Using Pennies to Test How pH Affects Copper Corrosion.↳ Forensic Science: Building Your Own Tool for Identifying DNA.↳ Electrolyte Challenge: Orange Juice vs.↳ Do Oranges Lose or Gain Vitamin C After Being Picked?.↳ Math & Computer Science Sponsored by Hyperion Solutions Corp.↳ Grades 9-12: Getting Ready for the Science Fair. ↳ Grades 6-8: Getting Ready for the Science Fair.↳ Grades K-5: Getting Ready for the Science Fair.↳ Science Teachers: Fairs, Projects, and General Support.We offer the White Vinyl Magnetic Strips in 1' to 12' widths in 30 mil. Choose from White Vinyl Magnetic Strips, Magnetic Strips with Indoor or Outdoor Adhesive, Sets of Match Pole Tape, and High Energy Magnetic Strips. ↳ Advanced Science Competitions (Intel ISEF, Intel STS, Siemens Competition, JSHS, etc.) Magnetic stripping is excellent for various uses around your house, in your office or garage, and for all your craft ideas.↳ Grades 9-12: Math and Computer Science.↳ Grades 9-12: Life, Earth, and Social Sciences.↳ Grades 6-8: Math and Computer Science.↳ Grades 6-8: Life, Earth, and Social Sciences.↳ Grades K-5: Math and Computer Science.↳ Grades K-5: Life, Earth, and Social Sciences.Active Forums (Make all new posts here).If your results are different for both strips, then you need to re-polarize one set of your strips. If your results are the same for both strips, then your strips are polarized correctly and should repel each other. Do the same thing for one of the magnetic strips on your train track. You can use a compass to check the polarity of the magnetic strips by holding a compass up to one of the magnetic strips on your train car and determine if the red tip of the compass needle points towards or away from the magnetic strip. If the magnetic strips are touching each other and their edges are aligned, you will need to repolarize two of your strips. Only do this after you have tried steps 1 and 2 to make sure your spacing is correct. If this happens, move the plastic angle pieces on your track closer together.ģ) The least likely possibility is that the polarization (which way the north and south poles face) of one set of your magnetic strips has been reversed, meaning the non-adhesive sides of the strips are attracted to each other instead of repelled. This gives the train car too much room to shift side to side, and it can be pulled down to the tracks instead of repelled. If this happens, move the magnetic strips on your track farther apart.Ģ) Your plastic angle pieces might be too far apart. However, here are the possible issues.ġ) The magnetic strips on your track might be too close together causing them to not be aligned with the magnetic strips on the train car. The project has a FAQ section that runs you through troubleshooting this issue that you should review for greater detail.
0 Comments
Leave a Reply. |